Hard disk recovery is required in the event of a crash that results in loss of information or lost photos recovery toronto.
Your hard drive has stopped working, preceded by strange noises such as creaking, clattering or clicking. Then it just stops and a lot of invaluable data is “locked” in your hard drive without knowing if you can use it again.
Hard drive is electronics with character. He has his own opinion on a number of issues. We can never know in advance how long a hard disk drive will spend, whether it is branded, old, new, crooked or straight. God’s work is the life span of the disks.
So, don’t rely on hard drives. They can always surprise you and mislead you most unexpectedly. Back up or copy files to cloud services so you don’t have to drink cold water afterwards.
Still, see how you can prevent a tragic ending, or repair damage. Be sure to read all the warnings before continuing.
Here are some ways to check your hard drive yourself.
First method Basic steps
- Look for damage on the outside and on the hard drive enclosure
- Stop using the hard disk drive or external media by safely unplugging it first.
- Shut down your computer altogether or shut down the device
- Remove the hard disk drive from the computer or the device with special care.
- Check for external damage or other damage to the controller’s external circuit board.
- Check for broken or damaged data cables and power cords.
Replace the cables. Plug in the hard drive with new cables (power and data connection) to make sure it works and try again. Note that the IDE disk will need a flat ribbon cable, and the SATA disk has a small color cable, usually blue, red, or black in color. Often the cables at the ends are broken, bent and screwed and need to be replaced with new ones.
If you have a PATA (IDE / EIDE) disk, push the switch. If it is “cable selection” switch to “default”. Plug it in without another port and try again.
Try another ID or PCI controller. If you do not have another controller, a PCI card that changes the ports on your computer, just change the ID.
Plug it into an external adapter disk or i.e. USB, if you have one.
Connect the device to another computer and try again. If it works, the fault may not be in the hard drive, but in the motherboard or the power supply of the computer.
Method Two – Use Linux to recover the data
Many times when Windows can’t see your device, it’s because the file system itself is corrupted. In that case, it would be a good idea to first check that this is not the case before you begin any recovery of the information. The reason for this is if you have a device that has a damaged file system, even a small physical breakdown can make things worse.
